6055

[BIGZERO]

I've been using the 6055 for a little over two months with the 7095 controller(along with 2 6100's). I heard a weird sound. After inspecting the unit the rotor where the blade is is completely stripped. The white part of the the shaft and the inside of the rotor wont hold for the blade to spin, the shaft spins and the blade stands still. This is after only 2 months. Anyone else with similar problems? I will give tunze a call on monday about replacing it.

Rob

 

[rvitko]

Pm me an address and we will send a new one, I have never seen that before, I could figure this would be caused by sand or maybe something jamming the prop or a defect in manufaturing but the drive unit is the same as the 6025 and 6045 with a slightly bigger propeller and I have never seen this before.