Is it possible to adjust the ouyput on the 6080 model. I seem to recall reading somewhere there is a screw on the powerhead unit to adjust the output downward by 30%.
Bryan, you probably read that on Canreef after I posted it . I later posted that I was mistaken about there being a set screw on the 6080. I think Roger will confirm this??
The 6080 cannot be adjusted- it is a synchronous pump it runs at 60hz which yields 3600rpm. Only the Electronic pumps 6100 and 6000 can be controlled because a computer controls the rotation speed and not the mains frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
