6095 alternating current and night mode with apex

[Joshporksandwic]

Hello Everyone, I have a 125 and recently upgraded from cheap ebay pumps to 2 6095s.

On my previous set up I had the pumps alternating on 15 minute timers. Ex. Left for 15 min right for 15min i would move the timer on 1 a little bit and you would get both on for around 5 min and 5 minutes of peace. Also I had the pumps completely off for the whole night from 11pm to 6am.

Is there a way I can do this with the apex. Alternating from left to right a few minutes of both off and a few minutes of both on and night mode where the pumps would go to the lowest setting (like 10%)?

I have a 7096 contoller and it was doing the left to right thing but wanted to use them with the apex.

 

[rvitko]

I am positive there is, it likely requires an additional module. It might be best to ask in the Neptune forum.

 

[Joshporksandwic]

I am positive there is, it likely requires an additional module. It might be best to ask in the Neptune forum.

I have all the modules and cables necessary. I just have no idea how to program. But i will post in the Neptune forum. Thanks

Sent from somewhere

 

[JPerkins2]

Not sure about Tunze's and how they communicate but say a normal powerhead would be...

Program outlet 1 as a normal pump and add...
If Time > 21:00 and < 0:600 then Off (this turns them off at night)

In outlet 2 add:
Set On
If outlet1 = on then outlet 2 =off
If Time > 12:00 and < 0:600 then Off

This will alternate them.