6100 driver not controllable

[vbsaltydog]

Roger/Craig,

I have a 6100 that does not respond to the 0-10v control signal. Its not the controller/cable/etc because I can plug the DIN into my other 6100 driver and it responds properly. Is there anything you can do (troubleshooting, replacement, etc.) ?

Thanks,

-Steve

 

[rvitko]

Make sure the potentiometer that is accessible on the left side of the driver box is turned up all the way. Besides that I don't have any ideas, it is likely the driver, but this part has not been available new for a few years and I haven't had used/refurbs in over a year, the parts for these older pumps are drying up.

 

[vbsaltydog]

Thanks Roger.