6100 installation on magnet holder

[AlienSpawn]

I just got in 2 6100's with magnet holders and the 7095 controller. I am putting it together and had a couple of quick questions. The instructions say the swivel attachment should 'snap' into place in the magnet holder but mine does not and I don't see how it is supposed to. Also it says to screw the swivel arm that attaches to the pump in to the sliding clip that attaches but there is not an appropriate screw and the clip does not appear to be threaded. Is something missing or am I not reading it right? Thanks!!

 

[bsackamano]

The clip doesn't snap into the magnet holder, it just rests at the bottom of the track. And I didn't read about screwing the swivel arm onto the holder, but you have to make sure the teeth on both pieces mesh so the pump doesn't swivel on its own.

 

[rvitko]

The screw is only applicable on the 6200. It only slides in place and as bsackamano said you have to be sure the teeth are firmly meshed.

 

[AlienSpawn]

great, thanks!

 

[AlienSpawn]

I just fired it up finally and the pump seems to want to 'walk' to the side. I have made sure the teeth are firmly meshed but it keeps happening. I will keep working with it but do you have any further advice?

 

[rvitko]

I can make a fix for you or you can just get a nylon screw, nut and two washers and just clamp the two pieces together that way. Home Depot has a lot of Nylon screws as does Lowes.

 

[AlienSpawn]

Thanks. I will just pick up some stuff at Lowes myself.