6101 Quit after one month

foltzcd

Member
Roger,

I purchased 2 6101's and a 7095 multicontroller from Marine Depot on 11/12/07. Today one of the pumps quit. I cleaned it, although it looked new. Nothing.

I changed the lines to the multicontroller. The good pump still worked the bad one did not. I have waited over two hours to see if there was an inside circuit that triped that would reset. The pump is still silent.

I am out of ideas. Any suggestions?

Chuck
 
Have you taken it apart yet to see if the impeller is ok and not "stuck" together somehow with the lower bearing? You can reference the sticky at the top of the forum if needed to check.
 
Found the problem. The 24V and 15 V converter is actually a fuse. The 24 blew so I changed to the 15 (lower flow) until I can get a replacement.

Roger, how do I get replacements?
 
Back
Top