6215, 6205, and old 6200.10 parts

[JPMagyar]

Roger,

1) I have a newer ball type Stream that is a 6215.200. The round holder is loose and no longer properly holds the ball tight enough. What part should I order?

2) I have a 6205 and I lost the small blue plastic tip and black washer that went on the end of the metal shaft, Again what part should I order?

3) For my old 6200.10 do they still make or have available the short 2 cm screw that went on top of the holding slider to lock the powerhead in position, and if so what part number is that?


Thanks as always for any help,

Joe Peck
Pound Ridge, NY






P.S. Can I phone the order directly to you or should I simply order online at Tunze?

P.P.S. Just ordered 2 new contollable 6105s from MarineDepot

 

[rvitko]

1)Typically that clamp just needs to be squeezed in to tighten it up, remove the pump and give it a good squeeze. What type of holder is the clamp mounted on, there are 3 different clamp types for old magnet holder or rail or new round magnet holder.

2)The only way to get these parts is a new 6205.700, this is probably worth doing as many parts have been upgraded in the last 6 months.

3)It is an 8mm screw, you may be able to find one locally, but the only way we have them is with the 6200.230 post piece.

 

[JPMagyar]

I only have the old magnetic holders with the rail. I'll try giving it a squeeze to see if that helps. I suspect the problem is of my own doing as I only have one clamp and I swap out the 6205 for the 6215 every month and it still holds the 6205 securely but not the 6215.

I see the 6205.700 and the 6200.230 great and thank-you.



But, before I order one more question.


My last 6200.10, which alarmed yesterday morning and which I worked on cleaning today is not gonna make it (after 5 years I figure that's o.k. )

anyways the question is:


Should I just order a brand new 6205 or is there some replacement policy that is worth taking advantage of that allows me to use the old round power supply, and if so what about the holder part?

Thanks again, and sorry for the numerous questions.



Joe

 

[rvitko]

Joe,

You can order 6200.015 on the tunze site. It is a 6205 with no magnet holder, it instead includes a clamp to fit your old magnet holder. The new power supply is included and required though. Unfortunately we are out of this part. We are also out of 6205. We expect both back in late January.