7092 controller

[Mark Bianco]

Roger,

I use to control my 6105 with my apex, however since I am upgrading to a larger tank I have moved my tank to another room and purchased a 7092 controller in the interm. Am I reading the instructions incorrectly. I have set the jumper to the middle setting. What I want to do is have the left run for 30 seconds then off, then the right run for 30 seconds then off I guess I would call it occalating. All I can acheive is both on all of the time no mater where I put the jumper or adjust the knobs.

Thanks in advance
Mark

 

[rvitko]

That time range is not possible on a 7092. For off and on 2 seconds would be the maximum time of wavemode, you could set an inverse pulse at 10 seconds so one was at 100 and the other was at 30. To do what you are looking to do a 7095 or 7096 would be required, the 7092 is a very basic controller and the only features are wave mode and pulse mode and these can be synchonous or inverse based on the jumper setting.