7096 Sequential - Random Issues

[PMG]

I'm trying to run my (2) 6105's in sequential - random mode, and it appears to be running in regular sequential mode.

I have one pump in port 1 and the other in port 3. Interval time is set to 4 sec, Pulse flow is set to 1.50 Sec.

Port 1 is set at 55% and 40%, and port 3 is set to 65% AND 45%.

With everything set as above, pump 1 runs for 4 Sec., then pump 1 and 2 both run for an additional 4 sec., then they both shut off, and start the cycle over again.

Shouldn't they be operating randomly at these settings?

 

[rvitko]

It is random in the sense that the pumps will kick on at 55% and 40% and 65% and 45% at random, because of the sequential timing, but it is not truly random.

 

[PMG]

Thank You.
I think I'll go back to interval mode with two pumps on one minute intervals at 70% and 30%.

 

[disaster999]

will the new updates solve this "non truly random" issue? are tunze pumps even capable varying flow from 30%-100% randomly like the vortechs?

 

[jh2pizza]

PMG - I found the same thing. I thought maybe I was misunderstanding what it should be doing.

 

[rvitko]

Yes, this is a mode we are working on, this is only a function of the controller and not an issue of pump capability.