Finally got my acrylic. I'll probably put together my ATS some time next week. Going to have to do something with the LRDs the cord is in the way at the bottom of the light.
Tried to drill the acrylic first pice came out perfect then the 2nd pice broke. I made the sides to small like a donkey. Going to order a new base and sides that are 1" to 1 1/2 wider.
Slowly but surely I'm getting the things I need. Should be ordering more acrylic soon then I'll get my ATS done. I also picked up those plugs that are on the remote for my mixing station.
Had to change out the plastic screws. The ones I had were junk. You couldn't tighten them for some reason. I glued the PVC drains together. Putting the PVC into the uniseals wasn't as bad as I thought it would be. Hopefully nothing leaks. I suppose I'll have to wet test it to make sure. I know the emergency drain should be bigger but with the size hole I would have to drill I don't think I could have got a way with it because of the width of the ATS. I didn't want to make it wider so I went with 1" for both drains and 3/4 for the feed pipe.
It's going to be a pain to clean your screen. I'll post a pic of my ats and how I have it set up I got the idea of A YouTube vib. Not my own but it's save time and headache. Trust me.
Watch the part where he has the rings holding the screen. It's made out the piece of pvc and then cut a small section of it. And your make a holder for the screen
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
