AC3, temp graph, non-functional

[sfsuphysics]

Just happened when I switched over the the new 3.4(?) firmware not too long ago. pH graph works fine, temperature graph however doesn't show up at all. It did initially now it won't. Shows up fine if I use aquanotes however.

I tried to flush the memory and that allowed the temp graph to show up for about a day, then poof away it went again. Looking at the datalog I don't see any "invalid" entries for temperature either it shows them all.

Any ideas?

 

[sfsuphysics]

Bump...

I know it's not an Apex question but geeze... is Curt on vacation or something?

 

[Deleted member 143833]

Have you called Neptune? This is a user supported forum and while Neptune does stop by but support from Neptune is done first by phone or email to support@neptunesys.com.