derek4real
New member
I have tried posting in the Neptune Systems Forum but they are not responding and is just being left unanswered.
I have been having problems with updating my ACJr to the new version (to use AquaSurf). The last step says the following:
7. On your PC in the cmd shell type "˜jrupdate aquajrser.enc "“COM1'
without the quotes. You should see a p[xxx] displayed on the second line of the LCD display if the update is working. After about 15 minutes the firmware will be done updating and the controller will restart.
The cmd screen does continue with the update and shows the progress but the ACJr does not do what this statement states.
Is there a way to see if my ACJr is "talking" to my PC. with out doing this update?
I am using 2 serial cable and having the same problem with both of them.
I have been having problems with updating my ACJr to the new version (to use AquaSurf). The last step says the following:
7. On your PC in the cmd shell type "˜jrupdate aquajrser.enc "“COM1'
without the quotes. You should see a p[xxx] displayed on the second line of the LCD display if the update is working. After about 15 minutes the firmware will be done updating and the controller will restart.
The cmd screen does continue with the update and shows the progress but the ACJr does not do what this statement states.
Is there a way to see if my ACJr is "talking" to my PC. with out doing this update?
I am using 2 serial cable and having the same problem with both of them.