Alarms on controller. What to do?

[Rendos]

I have a Multicontroller 7095 with four 6200 pumps. Two of my pumps make the controller alarm when they run. I have checked the pumps and cleaned them. The pumps are running when the alarm sounds. What do I do about the alarms...or what is causing the alarms?

 

[Jar*Head]

Try to swap the two propeller to see if it help. I did it before and fix the problem. make sure the rear bushing is properly seated. make sure the propeller spin freely.

Steve

 

[rvitko]

The alarms come from the driver box of the individual pumps, not the controller. They indicate the pump is either jammed or broken. The first thing to do is pin point the pumps that are alarming and disassemble them and clean them as outlined in the first thread in this forum and in your manual.

 

[Rendos]

Okay - I have cleaned them. I will try swapping the propellers and see if that helps.
If not, what do I do? Can I send them in for repairs?

 

[rvitko]

Yes. Just include a phone number and return address:

Tunze USA
305 Victor St
Austin, TX 78753