--------------------------------------------------------------------------------
I disconnected my Apex controller for a month while moving my tank around and now Im trying to reconnect it the way it was working before(with the same settings) its not working. Im a bit confused, I using a netgear 3700.
When I access the router, every once in a while when I click view attached devices I can see the address for the apex but only once in a while. I can ping the address from .cmd at any time, I've tried to log into the APEX through a wired connection(when the Apex device shows up on the router) and nothing happens.
All information on the apex display screen match my information. Is there something I have missed?? I can't even get the apex to work with DHCP mode on. I can get the apex to talk to the router and the router does assign a IP but the apex only stays connected for about a min. It will show up on the router attached device list for the first time I view it but not the second, third, ect.... but i can still ping it from .cmd????
Another route, I just set the apex to DHCP off, resest it, new Ip 192.168.1.210, New Ip can be pinged from cmd prompt, but doesn't show up on my router nor can I access my apex through web.??
I have connected to the apex with telnet using Ip address generated with DHCP off and on.
I have played around with reserved Ip, static and port forwarding options in the past but all those settings are now set to default. I haven't had the chance to upload the new software for the apex yet, still running4.04 -2B11. I have downloaded it to my computer but need a working network line to communicate first.
If anyone could help me out it would be greatly appreciated!!
Thanks,
Jason
I disconnected my Apex controller for a month while moving my tank around and now Im trying to reconnect it the way it was working before(with the same settings) its not working. Im a bit confused, I using a netgear 3700.
When I access the router, every once in a while when I click view attached devices I can see the address for the apex but only once in a while. I can ping the address from .cmd at any time, I've tried to log into the APEX through a wired connection(when the Apex device shows up on the router) and nothing happens.
All information on the apex display screen match my information. Is there something I have missed?? I can't even get the apex to work with DHCP mode on. I can get the apex to talk to the router and the router does assign a IP but the apex only stays connected for about a min. It will show up on the router attached device list for the first time I view it but not the second, third, ect.... but i can still ping it from .cmd????
Another route, I just set the apex to DHCP off, resest it, new Ip 192.168.1.210, New Ip can be pinged from cmd prompt, but doesn't show up on my router nor can I access my apex through web.??
I have connected to the apex with telnet using Ip address generated with DHCP off and on.
I have played around with reserved Ip, static and port forwarding options in the past but all those settings are now set to default. I haven't had the chance to upload the new software for the apex yet, still running4.04 -2B11. I have downloaded it to my computer but need a working network line to communicate first.
If anyone could help me out it would be greatly appreciated!!
Thanks,
Jason
