Apex PM2

[FuzzyLogic]

I hoping someone has experience with these. What if you have two PM2's attached to your Apex and want to enable temperature compensation for just one of them? When you select that feature it doesn't allow you select which PM2. What happens if I have a temp probe attached to one of the PM2's and not the other and set the temperature compensation feature to enabled?

 

[aquamanic]

The pH probes should have different names on each PM2. You select the proper probe name for the particular PM2 and enable temp comp.

 

[Deleted member 143833]

I hoping someone has experience with these. What if you have two PM2's attached to your Apex and want to enable temperature compensation for just one of them? When you select that feature it doesn't allow you select which PM2. What happens if I have a temp probe attached to one of the PM2's and not the other and set the temperature compensation feature to enabled?

On another note; temperature compensation ONLY works when the temp probe is connected to the PM2 that has the probe you want to be temp compensated. Temp compensation does NOT work accross modules (e.g., you cannot enable temp compensation in a PM2 to use the temp probe in the base).

 

[FuzzyLogic]

The pH probes should have different names on each PM2. You select the proper probe name for the particular PM2 and enable temp comp.

My second PM2 (Conductivity Module/Probe) wasn't showing up as a selection in the Temperature Compensation setting. I power cycled the Apex a couple of times and it finally showed up. All is good now.