Aquafuge HOB Installation

Capt. Nemo

Active member
Hi Jeremy,

Hope all is well with you. Can you help me out with installing my Aquafuge? I purchased this from you guys about a week ago. What I cant figure out is how to hook up the powerhead to the fuge. The instructions that CPR provides are a bit lacking. The instructions say that the powerhead( ViaAqua 480) should be attached to the refugium by inserting the outlet of the powerhead into the opening of the inlet assembly of the refugium.
The diagram on the back of the instructions shows the powerhead connected to the fuge's inlet. The powerhead comes with a couple of discharge adapters that I thought I would use to connect the powerhead's outlet to the inlet assembly. No such luck. The instructions that came with the ViaAqua say that you need to connect tubing to the discharge of the pump. I'm sure this should be a snap to put together. To be honest the instructions are pretty crappy and the pieces dont fit. Someone else with an Aquafuge told me the same thing. Your assistance is greatly appreciated. Thanks Jeremy!

Gary
 
Back
Top