Biocube owners (any size)

[Reno Reef]

A couple days ago I was using a dremel to cut a slot in chamber 1 so I could move a modded filter closer to the in take. The dremel was plugged in to the same powerstrip that everything else is plugged into. When I turned the dremel off the actinics shut off. Anyone else seen anything like this? Im not sure if the bulb itself went out or the ballast went out.

Ideas??

 

[smketyr]

Switch the bulbs around. You should then be able to tell if it is the buld or the ballast. HTH

Tom

 

[Reno Reef]

man im a moron... I didnt even think of that...

Thanks!

 

[al aziz85]

same suggestion!

 

[Reno Reef]

Well i switched the bulbs... nothing... so I unplugged the cord and as I was doing this I noticed that my timer had switched to off. I have no idea why the dremmel caused this to happen.

But now all is well. I laughed once I realized that it was something that I should have looked at first. I have learned a nice little lesson from this.

But thanks for everyones imput.

 

[davidhughes85]

well my ballast has been going bad on my atnics takes them like an hour or two to "warm up" b4 my light finally comes on....yall know if oceanic is good about sending a replacement?