Bracket illrustration beats me flat and hollow

[freddychin]

Tunze owners,

The Tunze stocks finally arrived in Singapore.

I brought the combination of 6000 stream x 1 unit and 6100 stream x 1 unit and multi 7094 controller. I also brought 2 set of mounting fitting, 3000-260.

The mouting bracket illustration beats me flat.

I intend to mount in on the horizontal glass plan on top of the tank. The bracket will be a inverted "L"

I am looking for the picture or illustration of the bracket especially the clamping portion.

Anybody can advise me.

rvitko, the picture you have is too small as I could hardly see the clamping portion as how the screw are located.

Please email me at frejoazo@singnet.com.sg

thx

regards

freddy
Singapore

 

[Jive Turkey]

Thats how I have it setup. I don't think I coud explain it any better than the pictures in the owners manual illustrate.

 

[rvitko]

The illustrations that come with the rail are really better than anything I could provide. I will try to walk you through this.

The flat piece with the rubber boot inside will go on top of the perimeter bracing, the knurled screw (for hand tightening) will go through the top hole and through the end hole in the rail you have cut to fit the width of the perimeter brace. Under the rail will be positioned the piece with a horseshoe notch in it. The screw with a standard head will go through the center hole and thread into the center hole on the piece ontop of the brace. This should be screwed down until it is snug. Then you will tighten the knurled screw down to get the final tension. Use one of the rubber spacers on the back of the rail that is under the brace. You will use the screw, nut and star washer at the back in the long notch to secure the horseshoe piece from the rail that runs down. Another rubber spacer will be fitted on the bottom of this rail.