Considering a skimmer replacement and need some advise

[Dano999]

I need to add a skimmer to the Aquafuge Pro I have. The internal skimmer is just not cutting it.

I am considering the 9010 or the 9015 as a replacement. The cup capacity has me concerned about the 9010 as there is no drain that I can see and I do travel some for business. Also can a 9010 handle a large bioload from a 90 gal with mainly SPS? The 9015 would be considered to remedy both of these issues but I don't want to buy more than what is necessary.

The picture below shows what I have to work with.

\

I want to put it in area D and have some questions.

1. Will microbubbles being introduced back into the tank since the return pump is close to the skimmer output?

2. Will an area of 6" X 11" be sufficient? The return pump will be moved to the bulkhead output C.

Thanks

 

[2crazyreefers]

The 9010 is L4.9 X W4.4 X H16.8 in. The 9015 is the same L & W but 18.8 in tall.

 

[Dano999]

Another question is whether the skimmer should be before or after the fuge or does it make a difference?

 

[Dano999]

bump

 

[rvitko]

I would run the skimmer before the fuge ideally. If the skimmer is near the pump, the risk of microbubbles is high. I would get the 9010, 700ml is about 10-20 days of skimming and when the cup is full skimming stops so it will not dump back.

 

[Dano999]

Roger

Thanks. Since I can't fit the skimmer in the area before the fuge I will need to get a new sump with a fuge.

At least if I only get the 9010 this will offset some of the cost.