Correct Drive Unit

[ROLLINS240Z]

I have a 6200.10 Steam that has a drive unit totally stuck inside. My alarm went off twice, and i pulled out the drive unit and did some quick cleaning, then a few days later it jammed for good. I tried pulling it out with pliers (I know bad idea ) and I ended up totally destroying/tearing the end of the shaft that the propeller goes onto. Im really upset at myself for lack of maintenance, and then I have to go and man handle everything without asking you guys, especially Roger, for help first.

1. How do I get this thing out? Is it OK to soak the whole motor
block unit in vinegar?

2. Is this the correct replacement drive unit part number?
Drive unit + propeller
6200.700

Thank you,

Rollins

 

[rvitko]

That is the right part. I see you work in autobody, you probably have the tools to do it. Use a small dent puller, the kind that looks like a mini slide hammer, just thread the screw down the center of the magnet #10 works the best for this, #12 can crack the magnet and make matters worse because it will then be wider and tighter. Secure the motor in a vice with rubber or leather pads to protect the motor. Use repeated medium strength pulls, don't pull too hard but depending how bad it is stuck, it may take some effort, but it is best to slowly pull it out.