Driver not functioning - what do I do?

[Doubledown]

Roger - this is a continuation post.

I dissassembled the drive unit (propeller unit) and checked it - all clean.

What I found was there was no power being sent to the controller from the driver.

I have 2 6100s and tried each transformer on the working driver. Each transformer powered the working driver so I have ruled out the transformer as an issue.


Is there a fuse or a shut off switch that I should check for?

What can I do (the pump is only 4-5 month old)?

Thanks
Chris

 

[rvitko]

Can you send it in? I have no problem replacing the driver for you, but to verify that the pump is safe and not the cause of the damage we need to run some tests. Otherwise we may just blow another driver and that is the most expensive part.

 

[Doubledown]

PM sent.

Wow - that is fast response. Thank you