Fixing my noisy MP10
- Thread starter Egkid
- Start date
Egkid
New member
You get your bearings yet Nwest?
It took a little while, but here's the video comparing the two side by side. Granted the stock one was the replacement I ordered about a year ago but I'd say it sounds about the same as new maybe a little louder.
http://youtu.be/xVZdHrhDaGI
It took a little while, but here's the video comparing the two side by side. Granted the stock one was the replacement I ordered about a year ago but I'd say it sounds about the same as new maybe a little louder.
http://youtu.be/xVZdHrhDaGI
gatoralum69
New member
Any feedback Nwest on those bearings of yours?
charleskeller
Member
I just changed mine and it is much quieter! The bearings where much cheaper off eBay though.
One tip, be careful getting the screws out of the housing. I stripped one out. :-( I drilled it out with a 0.098" drill bit and was able to disassemble it but now I need to find a replacement. It's back and working without it but I don't want it to go without for long. The side cutters where a great tip for removing the bearings from the shaft.
One tip, be careful getting the screws out of the housing. I stripped one out. :-( I drilled it out with a 0.098" drill bit and was able to disassemble it but now I need to find a replacement. It's back and working without it but I don't want it to go without for long. The side cutters where a great tip for removing the bearings from the shaft.
