wesheltonj
Member
I have successfully flash upgraded two of my three units. The third unit I cannot get it to fast blink while presssing the set button. Any suggestions?
Flashing problem
- Thread starter wesheltonj
- Start date
EcoTech Marine
.Registered Member
Hi wesheltonj-
Try placing the drivers as close as possible to one another and continue trying to re-flash. Sometimes it can take a few tries but it almost always works eventually.
-Tim
Try placing the drivers as close as possible to one another and continue trying to re-flash. Sometimes it can take a few tries but it almost always works eventually.
-Tim
wesheltonj
Member
I have them right next to each other and I can still not get the one to upgrade. Any suggestions other then to send it in.
EcoTech Marine
.Registered Member
Unfortunately the only thing I can suggest from here is to make sure that the upgrade steps are being followed carefully and that the drivers are close to each other, two things which I am sure you have done. We occasionally get drivers in which have had difficulties with the upgrade but 4 out of 5 times we are able to successfully re-flash them once we receive it.
If you decide to send it in, turn around is usually very fast.
-Tim
If you decide to send it in, turn around is usually very fast.
-Tim
