Fs-cell cast acrylic

[juststartingout]

I am selling off some misc cell cast acrylic panels that were cut down from a tank I had. The 3/4" panels are clear CRYO Acrylite GP. and measure as the following:

1) 24" x 30" $25.00
1) 27" x 91" $50.00
1) 24" x 90" $50.00
1) 26" x 30" $30.00

The following two pieces have one side painted black:
2) 13" x 26" $15.00 each or both for $25.00
1) 36" x 26" $35.00

The following pieces are new 1/2" thick Plexiglas G
1) 23" x 48" $45.00
1) 12" x 36" $20.00

Take the whole lot for $250.00

 

[2clown]

Nice prices. Makes me think about building another tank or sump.

 

[juststartingout]

pushing this back up

 

[juststartingout]

Saturday morning bump :dance:

I want to move this acrylic, throw me an offer

 

[scottieson]

I am interested in the 3/4 lot. I can't PM you due to being a newbie on the forum.

 

[juststartingout]

Scottieson: email me at christenson94@comcast.net

I have another couple pieces that measure roughly:

1) 24" x 48" 3/4"thick
2) 24" x 18" 3/4 thick

My preference would be to move the whole lot, so at the lot price listed I'll throw in these 3 additional pieces, the weld-on 4 & 16, applicator bottle & funnel that I have as well. Hows that for a deal?

If you don't need all of these pieces, you could sell some off to recoup some of your money.
The reason I am liquidating is that I am trying to clean up a bit and am driven to do so. :celeb3:

I also have a few auctions on the popular auction website, look for user 396rsss. I have some Tunze stuff, 1 Lumenarc III reflector, an MRC MR7R skimmer, and two Ice Cap 250wt MH ballasts, working, of course

 

[Volcano1]

Your a little bit of a hall for me or it'd be gone. Maybe a roadtrip if the weather stays decent.

 

[juststartingout]

Your a little bit of a hall for me or it'd be gone. Maybe a roadtrip if the weather stays decent.

It's a fair amount of acrylic for the price, it would be worthy of a road trip.

 

[juststartingout]

ttt

 

[juststartingout]

up top

 

[ChipE]

Interested, but how do you cut the 3/4" acrylic?
Do I need to bring it somewhere and pay to have them cut it? Do you know how much that cost?

 

[juststartingout]

I used my router to cut, but the edges are definitely unfinished. You can most likely use a table saw or perhaps a good circular saw to rough cut, (with a good blade). If your unsure, paying someone is a good route, because you'll get you pieces back at the measurement you need, no fuss. Not sure of the cost.

 

[juststartingout]

OK, I still have this acrylic. I'm not looking to "give" it away, but I would like it out of my hair Come take a look and make an offer...

 

[olivert00]

Sent a PM about one of the 3/4" pieces.
Thank you.
D

 

[juststartingout]

Hi D,

Sorry, hadn't checked my email or RC in a bit. I'll respond to your pm...

 

[olivert00]

PM sent on 5/7
Thank you
D