Looking for some troubleshooting advice. Reently I got 2 Tunze 6100.10 pumps with the 7240.27 drivers from a member of our local club. I finally got them wired in to my Apex Lite via an Aquasurf module last night. I programmed the Apex last night and turned everything on. One of the pumps is running the program correctly while the other one is staying at a constant power (I'm assuming 100%). I went over the Apex programming and don't believe that is the problem. The Aquasurf module's lights are flashing alternately on P1/P2 which leads me to believe the it is recieving the correct commands from the base unit. One pump is pulsing in rythym with the Aquasurf lights while the other is operating at a constant power when it should also be pulsing.
At this point, with my limited knowledge of these pumps and the drivers I believe there may be a problem with one of the 7240.27 Drivers. When I switch the Din5 cables from the Aquasurf to the drivers the problem is replicated but on the opposite pump. So I am confident the issue is not with the Apex Lite, Aquasurf or the pump itself. But I could be wrong.
Just looking for some thoughts or ideas. Maybe some troubleshooting steps I could do to isolate the issue.
Thanks,
Mike
At this point, with my limited knowledge of these pumps and the drivers I believe there may be a problem with one of the 7240.27 Drivers. When I switch the Din5 cables from the Aquasurf to the drivers the problem is replicated but on the opposite pump. So I am confident the issue is not with the Apex Lite, Aquasurf or the pump itself. But I could be wrong.
Just looking for some thoughts or ideas. Maybe some troubleshooting steps I could do to isolate the issue.
Thanks,
Mike
