My sump/fuge is setup as this. Its 30" x 16 x 16
Drain ||| Return | Fuge (| = Baffle)
The Fuge section has a baffle that is about 14" tall with overflow teeth cut into it. I'm getting bubbles from the water that is coming off the fuge back into the return section.
The Fuge is plumbed through by my return pump partially. I have a slow flow in there. The flow is slow enough so water is just cascading down the side of the baffle but since the return pump water level is so low (about 7") then I'm still getting bubbles.
This is a brand new setup so maybe a break in is required? I'm not sure. I know others must have the same type of setup. Any help would be appreciated.
Drain ||| Return | Fuge (| = Baffle)
The Fuge section has a baffle that is about 14" tall with overflow teeth cut into it. I'm getting bubbles from the water that is coming off the fuge back into the return section.
The Fuge is plumbed through by my return pump partially. I have a slow flow in there. The flow is slow enough so water is just cascading down the side of the baffle but since the return pump water level is so low (about 7") then I'm still getting bubbles.
This is a brand new setup so maybe a break in is required? I'm not sure. I know others must have the same type of setup. Any help would be appreciated.