Help with Wavebox/6100 setup

[PaulCom]

This may not be the right forum for this question, but here goes.

I have a 135 gallon bull nose tank (flat on one end, rounded on the opposite end). I have purchased a wavebox, a couple of 6100s and the multicontroller. I know the wave box has to go in a corner - but do you have any advice on where to place the 6100s?

Thanks,
Paul

 

[rvitko]

The wavebox just has to go on the flat end, whether or not it is in a corner is unimportant, the main thing is the outlet flow should be relatively unobstructed. I would set up the wavebox first, get it set to create the wave. What are the dimensions of the tank?

 

[PaulCom]

The tank dimensions are 48L x 24W x 30H. The bullnose radius starts 24" from the flat end. There is an overflow too, but since the tank has yet to be delivered, I'm not sure how far it is from the flat end.

 

[rvitko]

It may not be an ideal wavebox tank. I am unsure how the wide radius bull nose will affect it and I was expecting the overflow box would be against the flat end. I would place the 2 6101's in the corners on the flat end and probably alternate them using the controller in Interval 1 or 2.

 

[PaulCom]

Sorry - the overflow is against the flat end - I was trying to use too many words.....again......*L*

 

[rvitko]

I am not positive what effect the bull nose will have, I think it should be fine in general but some odd wave patterns may result.