Hex Tank Build

[griss]

You can go ahead and update them. If you don't a collective setup yet you will need to select each one then update the firmware on each one seperatly.

Thank you.

 

[griss]

Not sure what I’m doing wrong here. Tried to update firmware on my wave engine and getting this. Clicking reboot does nothing???

 

[griss]

Oh, I’ve got to click install. Told you I wasn’t technical.

 

[n2585722]

Oh, I’ve got to click install. Told you I wasn’t technical.

Did you get it downloaded and installed?

 

[griss]

Did you get it downloaded and installed?

Yes, I did. Thanks for your help.

 

[n2585722]

I got 2 Octo Pulse 2 pumps for Christmas. I already had a Wave Engine v2 I was using to control my MP10's with. So this is pump only with 2 adapter cables to hook them directly to the direct drive ports on the WEv2. These are replacing the MP10's. I now have them installed in place of the MP10's and hooked up. I setup the two outputs and added the outputs to the existing schedules so it was not too hard to switch them out. Also the Octo Pulse 2 pumps are only a little larger than the MP10's so they fit where the MP10's were mounted in the tank. I think I have the speed limits adjusted to match what the MP10's were doing. So far they seem to be doing great. I did leave the MP10 settings in the system but they are removed and powered down.