hey roger 6025.130 wont snap on

[sm fragman]

hey roger i wanted to thank you again for getting me out that new clamp for my tunze nano. i went and cleaned it up and put it all back together and the 6025.130 cap wont sit all the way down and when i turn the pump on it flies off most of the time. seem right arround the area where the cord is , is where it wont sit right ,,,,can i order a new one from you,, let me know i will get you payment info and shipping info ,,,thank you kind sir

shawn m

 

[rvitko]

Shawn was this a new 6025.13 or the same one you had before? If it is an older one I would suspect it has been compressed by the old clamp. If you squeeze it down to round it back out it should fit again. If the cord is in the way, you can just file the cord notch deeper. Let me know if this was something we sent or one you had already.

 

[sm fragman]

this is one i had already got it back in may ,i have tried rounding it back out , but to no avail it still jkeeps poping off in the course of a day ,,,,thank you sir

 

[rvitko]

Sure, PM me your address and I will send one.