How does 7095 contoller affect wavebox?

[ingros]

I have the following items that I am trying to coordinate through the 7095 controller: 2 6100s and 1 wavebox. The wavebox alone creates a tremendous wave that splashes onto my eurobracing 3"above the waterline. I've tried to reduce the power through the 7095, but it doesn't seem to have any effect. Does the wavebox controller ignore the 7095 and revert to its own settings, or am I simply doing something wrong with the 7095 set-up?

Also, Roger, what settings would you recommend for the above equipment on a 232 gallon 72x24x32 high? I have the wavebox and 1 6100 at one end and the other 6100 sits at the opposite side of the tank.

John

 

[rvitko]

The only way to adjust the wavebox is by the driver. The multicontroller only allows night mode and off for certain times with the Interval 1 operation.

 

[ingros]

Thanks for the quick reply, Roger. That explains why 1/2 hour of spinning knobs didn't affect the wavebox!

In night mode the wavebox still operates, however. Am I to assume from your post that it should stop or slow down somewhat when the lights are out?

John

 

[rvitko]

If you are using the photocell and the nightmode light is on and you use Interval I the photocell should turn off the wavebox at night if it is connected to one of the sockets that is off at night.

I asked Mr Tunze about this and he said the only way to lower wave height is to adjust the driver and use only the 6091 controller, if you connect the multicontroller it overrides the driver setting.