newby_reefer
New member
I am wanting to wire up 24 solderless 3W cree LEDs form rapidled in two parallel strings on one Mean Well ELN 60-48D dimmable driver. I have attached a diagram of how i think the setup should be. It should be noted that the areas where the black and red wires cross there is no electrical contact (I wasn't sure how to draw that part accurately). I am looking for advice from any one who has done this or has an electrical background and can tell me if my circuit will work. (please excuse my drawing as i know that it is not accurate from a electric schematic point of view, I are a mechanic) The plan is to split the output leads from the driver with a DC jack y-splitter and wire DC plugs into the heat sinks to plug the jacks into.
Questions:
Will this set up work?
Can the driver support 24 LEDs wired in parallel (or is it series parallel)?
What will the voltage to each LED be?
What will the current to each LED be?
Questions:
Will this set up work?
Can the driver support 24 LEDs wired in parallel (or is it series parallel)?
What will the voltage to each LED be?
What will the current to each LED be?