Is there a reason this code isnt working?

[tmgrash]

I made the mistake of hooking a friends apex into my eb8 and it kind of screwed everything up. Originally my system showed that my eb8 was 3, when I hooked his up it showed I had 3 and 4, and was running his programming. I finally was able to reset my base unti to recognise only one eb8 which was 4, well that was his with his programming not real sure how that happened (he was gone and his unti was no longer plugged in). Anyways I re-did all my programs but this one is not working anymore, the dosing pumps never come on.

Any ideas?

Fallback OFF
OSC 000:00/008:15/051:45 Then ON
If pH > 07.35 Then OFF

Thanks

 

[notclear]

I believe in most tanks PH will be > 7.35. So if you change it to > 8.35, then you should be fine.

 

[tmgrash]

Lol, how the heck did I oversight that!:hammer:

Haha, thanks

 

[swearint]

I finally was able to reset my base unti to recognise only one eb8 which was 4, well that was his with his programming not real sure how that happened (he was gone and his unti was no longer plugged in).

Just to clarify, the EB8 does not store any programming, although it does store a few bits of information, namely the bus address. When you hooked your EB8 to his Apex, it changed the bus address. Then when you re-installed it on yours, the Apex saw the new address and created new default programming. See pg 116 of the New User Guide V20 that is stickied at the top of this forum for more info on correcting the issue in the future.

Todd

 

[tmgrash]

When I hooked my eb8 back up to my apex it had 16 outlets showing 8 with my program and names and 8 with his programming and names. My apex chose to use his programming for some reason, the first 8 outlets listed were mine. Not sure how it all happened, I reset my apex to recognise the eb8 and it kept his names and programs and dropped all mine?

 

[swearint]

Then he was using the default programs, ie the pre-defined wizards. The EB8 does not store the code, the Apex base unit does. When it first recognizes an EB8 it populates with the default programs. When you reset your Apex, it deleted your customized outlets and reverted back to the defaults.

Todd