kit tide

[stephanec]

Hello with all,

I have a kit tide connected on 2 streams (placed on the same side because 3 visible faces) and I would have liked to know, according to the experiment of everyone, the best adjustment.

It is possible to make: simulation of swell, simulation of tide of which one which permer to alternate the pumps (100%-0%) and the other which makes it possible to alternate the pumps with a minimum (100%-30%).

Among these 3 combinations, which is the best for an aquarium récifal and which is the advised time of alternation.

Small survey...

 

[rvitko]

Hello Stephane, I will try my best to help but I am not real clear on what you are trying to do. We do have to French speakers in the company, Claude Hug in France and Phil Gilbert in Quebec. If you wish I can give you the email addresses.

I think what you want to do is have one pump off and one pump on and the pump that is on pulse from 30%-100%? What model controller do you have 7094 or 7095?

 

[stephanec]

It's a 7095.
You have right.
But I don't want a specific work.
I want just to move the sediments as much as possible.

 

[rvitko]

I think for a 400l tank the best program would be to place one pump in each corner in the back and aim the pumps to the front near the center. Use Interval program 1. This will run one pump at a time and you can adjust how long with the Interval control. Then you set the pulses for 1a and 1b to 30% and 100% and the same for 2a and 2b. Whatever 1b and 2b is is what the pumps will do at nightmode. You could also try Interval program 2 which is the same except the other pump does not turn off instead it runs as slow as possible. This is a good safety to keep fish away and it makes a little more flow.

 

[stephanec]

Thank you for your councils.