While working around my tank, I stepped on the plug of a WP 40 and broke off the ground. Can I remove this plug and replace it with another sealed plug or am I out of a WP 40? :smurf:
I'd cut the end off, go to the hardware store and get a new end to put on. They're cheap and easy to install. After you tighten the screw terminals, wiggle the wire a little bit, and tighten one more time.
That was my plan but I have read in the past that this could not be done as it would make the pump inoperable. I was basing my question on that. Just double checking.
I'd cut the end off, go to the hardware store and get a new end to put on. They're cheap and easy to install. After you tighten the screw terminals, wiggle the wire a little bit, and tighten one more time.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.