Looking for someone with wood tools and extra time..

[funman1]

Looking for someone to build me a small stand like 24" high and
20" long 15" wide or something like that.

I would work out exact measurements later but that's pretty close
Looking to put corner posts as 4x4 and then sheet all sides except the bottom with plywood.

This does not have to look good trust me. It's just for behind my tank where I want to put a 10G fuge.

Let me know what this would cost in wood and what you would charge for labor.

Thanks
~Steve~

 

[jlfnjlf]

Steve,

I think I could do it for you, but I need more details. Such as Ply thickness, doors, how much weight will it hold, and the likes. Also I could not start on it until next Saturday. As for cost I would need to make a trip to Lowe's to say, and labor well we can work that out later.

John

 

[MrMikeB]

Sure John has this covered, but my ShopSmith is available for use should you need it.

 

[funman1]

Thanks for the offer Mike... I'm like you, just don't have the time right now, and then trying to schedule a time to come over, and get the wood there, etc..
This is one project I just want to hand off to someone else, and pay them to do it




You were just the person I was thinking of but wanted to see if you were interested.

Ply thickness 1/4 inch would be fine for the top and 1/8 would be fine for the sides or all of it could be 1/4, I don't care.
No doors.
Needs to hold 8 gallons of water and 20 lbs of sand, so like ~120 lbs or so.

I know the 4x4's are way over kill but the seem to just make very stabe stuff. (Like my computer desk)

This does not have to look pretty at all.
I will get exact measuements later (Tomorrow perhaps)

Next sat is fine with me.
It's basically an upside down plywood box with 4x4 posts in the corners

What do ya think?