Loose and bent 6095 impeller post...

[sn4265]

It was suggested that I reach out here for help with a slightly bent and loose impeller post on a 6095. The pump still works most of the time but will periodically stop and I'll have to tap on it hard several times to get it to work. I think I got the impeller post mostly straightened out, it was only slightly bent to begin with. The real issue, I think, is that the post sits loose in the hole and easily moves up and down unlike the other pump where the impeller post sits firmly in the hole.

Thanks in advance for any assistance with this issue.

 

[rvitko]

I would send it in, I can press it back in properly if enough plastic remains to seat it. I am not far from you so turnaround would be fast-
Tunze USA
2121 Cole Springs Rd
Buda TX 78610