Mag mount rubber feet?

[Beenalongtime79]

Hey guys,

Does anybody know where I can find some new rubber feet for my Tunze mag mounts. The rubber feet are all worn down and I don't know where I can get some more. I can't find any on the Tunze site.

If anyone has any homemade remedies or has any idea where I might find these, please point me in the right direction.

Also, one of the clips on the mag mount (I have the 6080.50), where the sliding unit goes into that holds the Tunze has broken off... Is there anyway to actually get just one side of the Tunze magnet assembly. Since the other side is just fine.... then again, I guess they are exact identicals and I should just switch the dry side to the wet side since that one is still fine.... I guess I'm just being OCD. I'm just worried what will happen when the other side has that clip/tab break off.

Thanks so much,
John

 

[rvitko]

They are part 6200.509, you can get them on tunze.com but if you google 3M Bumpons you can find a lot of suppliers. I know Woodcraft carries them, they are usually used as rubber bumpers and feet for cabinet doors, cigar boxes, jewelry boxes, etc.

It is not possible to just buy half and past experience is 50% of the time the halves won't line up right if they are not a matched set.

 

[Beenalongtime79]

Thanks Roger! I guess it's off to Woodcraft for me.