Magnet holder 6080.50 defect?

[saltyc]

Is this a product defect?
I purchased a magnetic holder from a 3rd party company and the panels that what I assume cover the magnets were either loose or completely detached.
Should I send it back or can I re-glue them?

 

[rvitko]

They shouldn't fall off but those cover panels are strictly cosmetic, they only hide the real waterproofing of polyurethane underneath, they are just glued on to make it look a bit nicer. I am happy to exchange them if you send them back unused.

 

[saltyc]

Can I just super glue them back on?
The magnet is going to be used with a 6060 pump and from what I been led to believe I just need a 6080.230 slide on to mount the pump to the magnet.
Is this correct?

Thanks

 

[rvitko]

You can, the factory glue is tangit, which is basically like model airplane glue, I am also happy to send you a tube. This is correct, you need the magnet you have, 6080.400- the swivel arm that may already be on the pump and 6080.230, the post piece with hinge that mounts on the magnet.

 

[saltyc]

You can, the factory glue is tangit, which is basically like model airplane glue, I am also happy to send you a tube. This is correct, you need the magnet you have, 6080.400- the swivel arm that may already be on the pump and 6080.230, the post piece with hinge that mounts on the magnet.

Yes I'll take a tube of the glue but how should I ask for it when I place my order for the 6080.230?

 

[rvitko]

Just PM me your address, I'll take care of you on this.