Motor block problem

[frank arriaga]

Roger hope you could help with this one the top of the motor block has a slot were you would slide the swivel arm into the opening is a little to wide and the swivel keep falling off. How can I repair this.I have three of these 6100 pump. Thanks once again

 

[rvitko]

I would just glue it, while in the past I would have recommended trying a new one or modding a new one by melting and spreading the flanges, these pumps just don't have much life left and you can't replace the motors anyway (no longer available), so the simple fix is to just glue the arm to the pump with model cement, Tangit or even superglue. Odds are this repair will outlast the motor.

 

[frank arriaga]

Ok Thanks Roger.Will do.