mp60 too fast during feeding

[loveimac]

I just bought 2 mp60s for my tank, mostly lps.
l have tried feed mode, ang think it's still blowing too fast, so I setup it to be 0% during feed time, however even at 0%, it still runs fast enough and blowing too strong. I think at 0% it should be stopped or at least barely running, no? Any tricks or maybe mine is buggy?
Thanks.

 

[Rover88]

You might have to just turn them off.

Two MP60s is a lot of push. How big is your tank and where are they set up?

 

[mcgyvr]

Does the ocean slow down to allow fish/corals to feed?

 

[thegrun]

MP pumps will only slow down to 15% regardless of how low you set the %. A 0% setting will still result in the pump running at 15%, you need to program it to the off position.

 

[loveimac]

My tank is about 150G, and I use reeflink, and found nowhere I can program it to stop, please tell me where I can programly turn it off or maybe schedule it to true 1% to be safer?

 

[fijisrfr]

Umm... maybe push the right "œoff button" on the controller then turn back on when done feeding? But why? Fish love chasing food.



Sent from my iPad using Tapatalk

 

[lapin]

I turn the power "off" on my MP60's to feed. I do have 3 sea swirls with about 2500gph circulating in the tank while feeding. After a 10 min feed period I turn the MP60's back on to circulate the food that dropped onto the sand bed. I find the fish don't eat it off the bottom. It is an extra step but since i'm up feeding, its not that hard.

 

[Dmorty217]

The ocean doesn’t ever turn off, everything will be fine