Multicontroller 7095 problem

[noxiousdog]

I have a 7095 with two 6100s hooked up to it. However, in the past week, one channel keeps shutting itself off. It is related to the controller though, and not the pumps because if I exhange the connections, the opposite pump is the one that shuts off.

If I unplug both channels, it resets both channels and it will work for a few hours.

Is there something that can be tested, or does it need replaced?

 

[rvitko]

Have you tried a differnt cable, it sounds like bad cable.

 

[noxiousdog]

<a href=showthread.php?s=&postid=8658572#post8658572 target=_blank>Originally posted</a> by rvitko
Have you tried a differnt cable, it sounds like bad cable.

It doesn't seem cable related

------
|B   1-------6100A
|O   2
|X   3-------6100B
|    4
------

In this setup, the 6100B will shut off after a few hours.


------
|B   1-------6100B
|O   2
|X   3-------6100A
|    4
------

In this setup, the 6100A will shut off after a few hours.

 

[rvitko]

What mode are you running? In some modes this may be normal.

 

[noxiousdog]

I was running it on sequential. And I think you might be right. I saw in another thread that you highly recommended interval2, so I adjusted to put it there.

It seems to be working fine.

 

[rvitko]

In sequential witha 3hr interval this is how it would run.