My 6055s are noisy since I cleaned them.

[Harry_Fish]

I cleaned my 6055's for the first time
and ever since they are a bit noisy.

I have them on a controller and you can hear the noise
(vibration) rise and fall with the speed of the pump.

Any suggestions?

Thank you

 

[rvitko]

This is not uncommon, the drive unit will reseat itself and the noise will go away in a couple days. Just be sure that the shaft did not pull out and no sand is stuck inside the space between the shaft and drive unit. If the shaft was not pulled out the most common culprit is the shaft was bent slightly in cleaning and it tends to straighten itself back to the center as a result of the centrifugal force.

 

[Harry_Fish]

So in short... Just leave it alone?

 

[rvitko]

If the shaft didn't pull out and the drive unit wasn't hard to reinstall I would leave it alone for a couple days.

 

[Harry_Fish]

Thank you!