mystikal
New member
Got 90% of the cabinet done.
Before picture:
Still trying to figure out where I can put my Vectra remote...looks pretty odd in that one corner. I was thinking about moving it to the left side of the sump, but I am afraid it falls inside the sump. Unless I use the mount that it came with and is 100% sure it is sturdy.
I also built a wall to secure and enclose all of the unnecessary wires lol.
Didn't want to tighten down the a/c adapters too tight on the board but they are secure. The radions unit is sitting sideways, so it can get some air circulating. I ended up using a monster powerbar/surge protector because I opt out of getting an apex. Don't think an apex is for me at this time. Maybe in the future if I stumble across a good deal, then maybe....until then I'm happy how things are.
Here's the after:
I built the wall with the intent on using that ATO container. So it sits right below the floating shelf comfortably. I'm still debating on how o should run the ATO tubes/wires because it does not need to be in the back of the wall....I had issues with my past ATO and well...I like it to be accessible.
The floating shelf was a must, because I need to still keep my essentials at hand at all times. I may built more on the left side on top of the sump. But I'm also looking to get a nice doser to help with make life a bit easier.
So far, it's coming along as I envisioned it
Sent from my iPhone using Tapatalk
Before picture:
Still trying to figure out where I can put my Vectra remote...looks pretty odd in that one corner. I was thinking about moving it to the left side of the sump, but I am afraid it falls inside the sump. Unless I use the mount that it came with and is 100% sure it is sturdy.
I also built a wall to secure and enclose all of the unnecessary wires lol.
Didn't want to tighten down the a/c adapters too tight on the board but they are secure. The radions unit is sitting sideways, so it can get some air circulating. I ended up using a monster powerbar/surge protector because I opt out of getting an apex. Don't think an apex is for me at this time. Maybe in the future if I stumble across a good deal, then maybe....until then I'm happy how things are.
Here's the after:
I built the wall with the intent on using that ATO container. So it sits right below the floating shelf comfortably. I'm still debating on how o should run the ATO tubes/wires because it does not need to be in the back of the wall....I had issues with my past ATO and well...I like it to be accessible.
The floating shelf was a must, because I need to still keep my essentials at hand at all times. I may built more on the left side on top of the sump. But I'm also looking to get a nice doser to help with make life a bit easier.
So far, it's coming along as I envisioned it
Sent from my iPhone using Tapatalk