Hansen1142
New member
Hi.
I have a problem with my Osmolator.
The black sensor is set to point down as the manual says, and the floater is set a little higher, also as it should.
When the waterlevel goes to low, the Green light stops, and the Orange "Pump on" light turns on, and it begins to fill up water.
But then when the level is reached, the Green "Level" light is turning on again, but the Orange "Pump on" keeps being on, and the pump fills water for about 20-30 seconds, before it stops, and it results in the "Beep" noise from the "To high" level sensor.
I've tried cleaning the Optic sensor, but no change. It keeps filling water up for atleast 20sec after the green light turns back on. What can i do?
I have a problem with my Osmolator.
The black sensor is set to point down as the manual says, and the floater is set a little higher, also as it should.
When the waterlevel goes to low, the Green light stops, and the Orange "Pump on" light turns on, and it begins to fill up water.
But then when the level is reached, the Green "Level" light is turning on again, but the Orange "Pump on" keeps being on, and the pump fills water for about 20-30 seconds, before it stops, and it results in the "Beep" noise from the "To high" level sensor.
I've tried cleaning the Optic sensor, but no change. It keeps filling water up for atleast 20sec after the green light turns back on. What can i do?