Phosban Reactor - ON-LINE

[fish1219]

Hello,
I finally installed my phosban reactor. I had to remove the skimmer because of overflow problems. The skimmer was external to the sump and after dumping 10gals of water onto the floor it had to go. Now, regarding the reactor.
* How much should the phosban tumble. Instructions says slightly
* What should I watch out for, both good and bad.
* Is anyone running 2 reactors. One for carbon and one for phosban.

Any suggestions regarding the reactor. Its from Two Little Fishes.

Fish1219

 

[POSEIDOMORS]

i run two reactors(kent marine), one for each. i fill them about a third of the way up the chamber. i have seen people run both in one reactor. with no ill effects. it all depends on the amount of media being used. i use maxijet 1200(295gph) power heads, which is about three times the recommed flow(normally around 100gph). i use a small carbon media(saltwater correct), and have noticed that it will compact in the bottom if the flow is to slow. hope that helps a little.