Roger,
I installed one of my holding tracks on the glass using the 4 threaded platelets I got from you and some adhesive silicon. The best solution for a system built into the wall.
I did not pre-mount the sliding mounting device and post for the swivel holder on the track before screwing in the platelets and installing with the silicone. The problem is the sliding mount part does not pass over the screws placed in the track. Currently the pump is installed at the bottom of the track and upside down. Not the preferred install I am sure.
Any suggestions on how get the sliding holding device over the screws? Or do you have any other mounting options to get the pump higher on the track? Or do I need to remove the track and start over?
Thanks, Mike
I installed one of my holding tracks on the glass using the 4 threaded platelets I got from you and some adhesive silicon. The best solution for a system built into the wall.
I did not pre-mount the sliding mounting device and post for the swivel holder on the track before screwing in the platelets and installing with the silicone. The problem is the sliding mount part does not pass over the screws placed in the track. Currently the pump is installed at the bottom of the track and upside down. Not the preferred install I am sure.
Any suggestions on how get the sliding holding device over the screws? Or do you have any other mounting options to get the pump higher on the track? Or do I need to remove the track and start over?
Thanks, Mike
