Please help with tunze 2x 6100.10 and 7095 controller

[reefsahoy]

The audible alarm goes off whenever the power head gets signal from the controller to run. I've took apart the entire pump and cleaned the pump as per http://reefcentral.com/forums/showthread.php?threadid=1071516 instructions and it still doesn't work. If i manually turn the impeller it will run for a few sec and then stutter if the speed changes. I then plug it into a different port in the controler that i know works the other pump and still the same problem. I would think i need the impeller, bearings, rubber ring, and outer ring that snaps into the pump itself. Where can i get these items or do i need to send in the pump? Is there a cost for the repairs?

thanks
Nick

 

[chercm]

i think Roger can help u on this

 

[rvitko]

Usually on a simple repair like this it would just be the cost of parts, worst case scenario, it would likely be just under $100, but probably somewhere between $30 and $75.

Send me the pump:

Tunze USA
305 Victor St
Austin, TX 78753

 

[reefsahoy]

Roger, do i need to send the transformer or can i just send the driver and pump?

thanks
N

 

[rvitko]

Just the driver and pump.

 

[reefsahoy]

it's on the way. it should be there by tomorrow 10:30 fedex

 

[reefsahoy]

Sorry for such a late reply! Thanks Roger your help! Not sure why the noise went away but the fact it did was great. Been using it now for like 2 weeks without any issues. Your help was greatly appreciated. just one more happy customer reporting!! thanks again!