PraziPro and Cupramine in Quarantine Questions

[nuxx]

Hey guys,

I'm curious if I could run PraziPro and Cupramine at the same time in quarantine.

Was planning to give the fish a few days to get used to the QT tanks and start eating.

Then wanted to start the first dose of PraziPro.

Since I'm going to have some wrasses and angels in the tank, I wanted to bring up the Cupramine slowly over a week and also only do a .25-.3 dosage.

Would it be ok to start ramping up the Cupramine during the first PraziPro treatment?

Anything I should look out for?

Thanks!

 

[Dmorty217]

I believe this is ok to do, when in doubt call seachem and talk to them about drug interactions with their products.

 

[nuxx]

I believe this is ok to do, when in doubt call seachem and talk to them about drug interactions with their products.

Thanks, I'll shoot them an email

 

[hobbzz]

I've done this multiple times with no problems. Seachem always tells people never mix their products to eliminate their reliability. There are lots of threads on here from people with the same results as me though.

 

[nuxx]

Awesome should save a lot of time and allow more time to monitor after treatment

Basically was going to burn a week after PraziPro treatments to raise Cupramine levels.

So saves like 17 days haha

Also, anything wrong with dosing Stability everyday through the entire QT procedure? The cost of Stability is low versus the fish. Just want ammonia to be 0 the entire time. Have some seeded sponges and ceramic media as well.