Profilux 3 and Tunze Nanostream 6055 connection

Luckylouse

New member
Please help. I'm pulling my hair out getting my Tunze Nano going with my profilux.

I put the Nano cable into L1L2.

Called up the 1-10V interface and called slot 1 Current Pump 1.

went to Extra/ Pumps and it won't communicate to the pump.

Help. I was going to move away from Vortec's and sell my MP 40s for Tunze... but not if I can't get them working.

HELP! Thanks!
 
are you sure you have Tunze 1 cable? try assigning it to L2 and see if it then works, if so then you have a Tunze 2 cable.

Other than that there is something not set up quite right in the pump set up screen
 
Ya.. You were right about the cable. Tunze 2 so I put in under L2... I was able to make changes and save them so I know the profilux ix updated but the Curent pump still stays on constant. Do I need to do anything with the voltage on the power supply? Does it need to be fully on at the highest voltage?
 
the voltage on the L port ust be set to 3-8V but this would not stop it from performing

screen shots of your pump set up would be great.
 
Back
Top