Profilux doser problem

[mawk]

My profilux doser (6 months use since date of purchase has been restricted to dosing with channel 5 and 6 only - the unit is run off a standalone programmable profilux doser) has developed a fault.

I noticed it this morning when all four dosing pumps had activated and were pumping at the same time - before switching off in line with standalone doser programme. I found this particularly strange as doser channels 7 and 8 are not programmed to run by the standalone doser. On further inspection I found none of the 4 manual dosing buttons work either (pushing in the buttons does not result in the doser pumps activating).

Switching off and restarting the units does not make a difference. Units are setup away from the tank to ensure no contact with water. Any ideas?

Otherwise nothing but praise for these products - just looking forward to have a working unit again.

M

 

[AQD_ottawa]

Most likely (99.9999% of the time) reason is water has got into the bottom left front corner where the ribbon cable joins the motor mount board and corroded the pins thus creating a short.

Take the unit apart including removing the front black motor mount board and take the ribbon cable off noting the direction it came off. Check the pins.

If no got and based on the USA or Canada only email me sales@aqua-digital.com